※ Investigations found that the following causes can all lead to the "surface whitening" phenomenon on real stone paint finishes:
1) The primer does not meet the requirements, with high water and vapor permeability, or ordinary latex paint sealer is used instead of primerReal stone paintA dedicated primer, causing moisture in the wall to penetrate into the real stone paint coating; if the intermediate coat of real stone paint is not completely dry and has vitrified, when the external temperature is low or the moisture is high, the moisture inside the real stone paint concentrates and condenses under the topcoat film, causing the surface to turn white;
2) Insufficient wall dryness, low compactness of the plastered surface, or partial omission or non-dense application of the sealing primer causes moisture in the wall to penetrate into the real stone paint coating that has not yet fully vitrified. When the outside temperature is low or the moisture is high, the moisture in the real stone paint condenses under the topcoat film, causing whitening on the surface;
3) Real stone paintIf the temperature is low or the air humidity is too high during spraying, the degree of coating drying and vitrification is low and the moisture content in the coating is too high. In this case, if a topcoat is applied, the moisture in the real stone paint will volatilize more slowly. When the outside temperature is low or the water vapor is high, the moisture in the real stone paint will condense under the topcoat film, causing the surface to turn white, and sometimes the whitened coating will also soften;
4) The use of topcoat that does not meet requirements, poor water resistance of the topcoat, or omissions in application or an insufficient number of coats during topcoat application, which allow external moisture to penetrate, can also cause the surface to turn white;
5) Real stone paintThe formulation system has defects and poor water resistance, which can not only cause large-area surface whitening but even cracking and detachment;
※ In response to the above causes, it is recommended to take the following measures for preventionReal stone paintOccurrence of the "whitening" phenomenon on the facing:
1) Correctly select real stone paint series products; it is recommended to purchase products from regular, professional manufacturers and avoid using low-priced, inferior products from non-professional manufacturers;
2) Do not use latex paint sealer as a substitute for the sealer for real stone paint, because the functional systems of these two products are different. General coatings require the primer to have a certain vapor permeability, whereas the special primer for real stone paint has very low vapor permeability and can isolate most of the moisture in the wall;
3) For walls that are poorly dried or unevenly dried, it is advisable to use an epoxy-series sealing primer, and the application must be thorough and complete, with no skips or missed areas, to increase the barrier against moisture inside the wall;
4) During construction, if the surrounding environment is not easily accessible toReal stone paintCause no pollution; delay the topcoat application as much as possible to increase the drying and curing degree of the real stone paint;
5) Use oil-based resin topcoat or topcoat with high weather resistance as much as possible, and apply it thoroughly and in place to increase protection for the real stone paint and prevent the intrusion of external moisture;


WhatsApp
Guangdong Public Network Security Preparation No. 44200002005257